Swab Dryer (3-3600)

The Lightning® Powder Swab Dryer was designed to provide a contaminant-free environment for drying swabs. It was also designed to draw a gentle flow of air around the swabs to remove moisture that may cause bacteria growth during storage. The Swab Dryer is constructed of sturdy Lexan and has a latched access door which leads to a drying compartment. There is a 20-swab capacity drying rack built in.

The Swab Dryer has two particulate filters, one on the door and the other at the rear exhaust port (see photos). Both filters are made of spun plastic fibers and can be removed and cleansed with a standard laboratory cleanser. To remove filter pads from panel in order to clean, gently squeeze the sides of the filter and pull. To re-install a clean filter, place filter in cover and simply snap back into place.

Upon receipt of Swab Dryer:
It is recommended that the Swab Dryer and rack be cleaned prior to use. DO NOT immerse the Swab Dryer into water. This will cause an electrical failure and may cause injury. Simply wipe the surfaces with a soft cloth and laboratory cleanser and rinse with clean water and a clean soft cloth. Do not use abrasives to clean.

Operation:
When drying multiple swabs use a marker or adhesive letters/numbers to mark and identify the grid positions to help eliminate confusion. Place swabs in the rack, then place rack in the dryer and close the door. Turn on the fan and run until swabs are dry. Drying swabs may vary in time, depending on the content. Keep a chart to help determine the optimal dry time for the different contaminants on the swabs. A timer is included to assist you with drying time. When swabs are dry, turn off fan and remove the rack from the dryer, then remove swabs and packages according to your department's evidence handling guidelines.